FUTABA 3PM 3ch 2.4GHz RC Model Transmitter & R603FS Receiver TS850

USD195.7USD205.9 (-5%)

Out of stock

FUTABA 3PM 3ch 2.4GHz RC Model Transmitter & R603FS Receiver TS850. This is 100% Brand new item and we can ship this item to worldwide.

SKU: TS850 Category:

Thank you for interesting a 3PM 2.4GHz system. This system is based on the combination of the newly developed 2.4GHz transmitter and its correspondent receiver. The system utilizes the 2.4GHz-SS radio communication and an ultra small antenna. In addition, the system inherits Futaba`s unique HRS (High Response System).

Communication Method: One-way operation system
Mode: PPM, HRS (Auto-detect)
Maximum Operating Range: 80m (Optimum condition)
For Safety: F/S, B-F/S, ID
Transmitting Frequency: 2.4GHz band
Channel: 3ch
Current Drain: 250mA or less
Transmission Antenna: 1/2 mono-pole

PLL Synthesizer System (transmitter T3PM-FS only) – 3PM PLL synthesizer transmitter is easy to change the frequency only by selecting a desired frequency on a transmitter LCD screen.

High Response System (H.R.S.) (Receiver R203HF only) – When used with the H.R.S. system, a speed of triple that of an FM system at average response is realized. (Comparison with other Futaba products)

Simple segment type LCD display and four edit keys for easy data setup

10 models memory – Model names can use up to 3 letters, numbers and symbols so that easily understood names can be set. Model copy function simplifies creation of a model memory with different fine setups.

Two function groups : Frequently used functions / System functions – Frequently used functions can be easily called from the initial screen with Select Key (SEL).

Brake mixing for large cars (BMX) – Brake mixing of the front and rear wheels of 1/5GP car, etc. has balance adjustment functions.

Steering dual rate (D/R-ST) – Steering angle can be adjusted with digital trim lever.

Anti-skid Braking System (ABS) – This function applies the brakes so that the tires of gasoline engine cars, etc. do not lose their grip on the road even when braking at corners.

Throttle acceleration (ACC) – Gasoline engine cars have a time lag before the clutch and brakes are connected. The ACC function minimizes this time lag.

Steering speed (SPD) – When you sense that the steering servo is too fast, etc., the servo operating speed (direction that suppresses the maximum speed) can be adjusted.

Racing timer (TIMER) : Up timer or Down timer can be selected. – A lap time can record 100 lap times and the total time. The timer can also be started automatically by trigger operation. The race time can be set.

Digital trim : Steering trim, Throttle trim, Steering D/R – The current position is displayed on the LCD screen for about three seconds when each digital trim is operated.

Function select lever function (FNC-DT1/DT2/DT3/DT4) – This function assigns a function to levers (digital trims, grip levers). Trim positioning at each model call is unnecessary because all the levers are digital.

Function select switch function (FNC-SW1/SW2) – This function assigns a function to the two installed switches.

Condition 2 Selection – In specific functions, two rates can be set up, and switched with SW1 switch simultaneously during a run.

NEW design considers operability and weight balance

Tension adjustment function – The wheel tension can be adjusted from the outside.

Trigger stopper function (mechanical ATL)

High luminosity blue LED pilot lamp – You can select your desired brightness of the pilot lamp. (Four steps)

Dimensions: 39 x 26 x 14mm
Frequency: 2.4GHz SS
Channel: 3ch
Power Requirement: 6V Nicd battery
Reception antenna: Diversity type

Item Included: 1 x Futaba RC Model 3PM 3ch 2.4GHz R/C Hobby Transmitter & R603FS Receiver TS850



Additional information

Weight876 g
Dimensions45 × 25 × 20 cm
Submit your review

Your email address will not be published.


There are no reviews yet.

See It Styled On Instagram

    Instagram did not return a 200.
Select your currency
EUR Euro
USDUnited States (US) dollar

Main Menu